Operation With The Remote Control; Replacing The Battery; Function Options - IMG STAGELINE LSX-300TEXT Mode D'emploi

5.3 Operation with the remote control

The remote control (fig. 2) is supplied with a
battery. Prior to initial operation, remove the foil
from the battery holder. When pressing a but-
ton, always direct the remote control to the sen-
sor IR (8) so that the LED (7) starts flickering to
confirm reception. There must be no obstacles
between the sensor and the remote control.
If the unit is not used for a longer time,
remove the battery from the remote control as
a precaution so that it will not be damaged in
case the battery should leak.

5.3.1 Replacing the battery

1) Push the latch of the battery holder to the
right (first arrow in fig. 7) and remove the
holder (second arrow).
1. 2.
2) Remove the old battery and insert the new
battery (3 V button cell, type CR 2025) into
the holder with the positive pole facing
upwards.
3) Push the holder back into the remote con-
trol.
Batteries must not be placed in the
household waste. To protect the
environment, always take them to
a special waste disposal, e. g. col-
lection container at your retailer.

5.3.2 Function options

All modes can be selected by means of the
remote control (refer to chapters 5.2.1 to 5.2.5
for a description of the modes). In some
cases, however, the operation is different from
the operation with the keyboard; therefore, it
is briefly explained in the following table.
Button
Press briefly: to switch the laser beam
ON / OFF
keep pressed for 3 sec.: standby mode
AUTO Mode
Select the different topics with the
AUTO
numeric buttons.
“
Remote control functions
’
Replacing
the battery
Function
on / off
Button
MUSIC Mode
Select the different topics with the
numeric buttons.
To set the microphone sensitivity: keep
the button pressed for 2 sec.; then set
MUSIC
the sensitivity with the numeric buttons:
1 = lowest level of sensitivity
9 = highest level of sensitivity
CLOCK Mode
Press this button again to change
between the indication of the time and
the alternating indication of the time and
the date.
To set the time and date:
1) Keep the button A pressed until the
year date starts flashing. Enter the
year with the numeric keys.
2) Go to the month date with the button
A
, and then enter the month. Repeat
this procedure to set the day, the hour
and the minute.
3) Go to the indication 12R or 24R with
the button
ton 1 for the 12-hour indication, or
press the button 2 for the 24-hour indi-
cation.
4) Press the button A to save the set-
tings.
COUNTDOWN Mode
To change the countdown time, keep the
button B pressed until the time starts
flashing. Enter the time with the numeric
buttons.
To start the countdown, press the button
B B. Pause the countdown and continue it
at any time with the button II.
To restart the countdown, keep the but-
ton B pressed until the time starts flash-
ing. Enter a new countdown time, or
briefly press the button B to start the
countdown.
TEXT Mode
C After pressing this button, select the
saved text with the numeric buttons.
Pause / continue the run
Change the laser colour
to return to the original colour:
Press the button for the mode.
Mirroring :
Function
. Press the numeric but-
/ / /
17