Operation At The Unit; Recharging The Clock Battery - IMG STAGELINE LSX-300TEXT Mode D'emploi

5.4 Operation at the unit

WARNING When
MODE (2), make sure that you
stand next to the laser unit in
such a way that you cannot look
into the laser beam.
Press the button MODE (repeatedly) to
switch on the following modes. The colour of
the LED (7) will indicate the mode selected.
– Text mode (LED: purple)
– Show mode with all topics (LED: red)
– Music-controlled run
(LED: lights up in blue when a sound event
is received)
If no sound event is received within 10 sec-
onds, the laser beam will be switched off
and the LED will constantly light up in blue.
The laser beam will be switched on again
by the next sound event of sufficient vol-
ume.
Use the remote control to set the micro-
phone sensitivity, refer to chapter 5.3.2,
fig. 8, button
– Projection of time (and date)
(LED: red and purple alternating)
The setting most recently made by means
of the keyboard or the remote control
defines if only the time is indicated or if it
alternates with the date.
Keep the button MODE pressed for 2 sec-
onds to switch off the laser beam; briefly
press the button to switch the beam on again.
18
actuating the
MUSIC.

5.5 Recharging the clock battery

The laser unit includes a rechargeable bat-
button
tery so that the internal clock for the time indi-
cation will continue to work when the unit is
switched off. The battery will be automatically
recharged when the unit is connected to a
mains socket via the power supply unit.
A fully charged battery will be able to
keep the internal clock up to date for up to
2 months. If the battery is discharged, only
the time and the date must be set during the
next operation.