Operation; Entering Text With The Keyboard - IMG STAGELINE LSX-300TEXT Mode D'emploi

WARNING 1. Since different safety regula-
2. When installing the unit at a place where
people may walk or sit under it, addition-
ally secure the unit (e. g. by means of a
safety rope fastened to the mounting
bracket; when fastening the safety rope,
make sure that the maximum falling dis-
tance of the unit will not exceed 20 cm).
3. Mount the unit at a location where suffi-
cient air circulation is ensured during
operation. Never cover the air vents (11).
The minimum distance between the unit
and the adjoining walls must be 20 cm;
the minimum distance between the unit
and the projection surface must be 50 cm.
4. Please note that fast changes in lighting
may trigger epileptic seizures with photo-
sensitive persons or persons with epilepsy!
5. Only operate the laser unit with a laser
safety adviser being present. When
leaving the unit, the laser safety adviser
should use the key switch (10) to protect
the unit against unauthorized operation.
1) Use the mounting brackets (6) to fasten
the unit at a suitable location, e. g. by
means of a stable mounting screw or a
support for lighting units (C hook) on a
crossbar.
To align the unit, loosen the two
setscrews (5) on the mounting brackets.
Tilt the unit as desired and then firmly
retighten the setscrews.
2) As an alternative, the unit can be set up as
desired: Spread the mounting brackets
below the unit so that they serve as a sup-
port. Then retighten the setscrews.
3) For entering texts, connect the keyboard
with its USB plug (15) to the jack PS2 (13)
by means of the adapter (16). If required,
14
tions apply in each country,
always make sure to observe
the regulations of the country
in which the unit is operated!
use the 5 m extension cable provided.
(However, it is not necessary to connect
the keyboard for projecting saved texts.)
4) For power supply, connect the power sup-
ply unit to the jack 12DC (12) and to a
mains socket (230 V~ / 50 Hz). This will
switch on the unit; the LED (7) will light up
in the colour of the operating mode most
recently selected.
5) To switch on the laser beam, insert the key
provided into the lock LOCK (10) and then
turn the key to the position ON.
6) Using a thin screwdriver, adjust the projec-
tion size desired by means of the control
SFZ (14).
7) If the unit fails to work as usual, it can be
reset by means of the Reset button (1):
Insert a thin, electrically non-conductive
object (e. g. small plastic pin) into the drill
hole of the housing to press the button.

5 Operation

Most functions are provided by the keyboard.
With the remote control, many (but not all)
functions can be controlled. At the unit, the
button MODE only allows to select the oper-
ating mode and to switch the laser beam on
and off.

5.1 Entering text with the keyboard

1) Press the key
jected, i. e. the text mode is selected.
(For selecting other modes, refer to chap-
ter 5.2.)
2) Press the Enter key to confirm the text
mode; the text most recently projected will
appear.
3) Press the key
then enter the text desired.
4) Various effects are available; they can be
combined, if required. Press the appropri-
ate key repeatedly to switch an effect on,
. "1. TEXT" will be pro-
Del to delete the text, and