Cleaning - SilverCrest SAS 7.4 LI B1 Mode D'emploi

1) Remove the handheld vacuum cleaner from the wall bracket
2) If required, place the appropriate nozzle in the suction opening:
NOTE
►
3) To switch the appliance on, slide the on/off switch
4) When you have finished using the appliance, slide the on/off switch
NOTE
►

Cleaning

To achieve the best results, empty the dirt container
after every use.
CAUTION! MATERIAL DAMAGE!
►
1) To open the dirt container
2) Remove the dust filter
3) Empty the dirt container
4) Pull the dust filter bag
5) Rinse the dust filter bag
6) Reinsert the dust filter
SAS 7.4 LI B1
not using the wall bracket
–
the crevice nozzle
–
the wet suction nozzle
After you have vacuumed up liquids, immediately clean the dirt container
Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag is completely dry before using the appliance again.
indicator lamp lights up green.
the rear.
Place the handheld vacuum cleaner in the wall bracket
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp
Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
dirt container .
dry before reinserting it into the dust filter
that the dust filter is seated squarely and that the rubber lip seals the dirt
container .
remove the barrel plug
, to clean narrow and difficult to reach locations.
to vacuum up liquids.
flashes green.
, press the release button
from the dirt container
.
with its holder out of the dust filter
out in cold water and wait until it is completely
. Do not dry it with hot air.
into the dirt container
or, if you are
from the socket.
forwards. The charge
and start the
and clean the dust filter
and remove the
.
.
. When doing so, ensure
GB
.
to
│ 33 ■