Installation Of The Wall Bracket - SilverCrest SAS 7.4 LI B1 Mode D'emploi

2) The batteries reach their full capacity after a charging time of 24 hours. For

Installation of the wall bracket

►
1) Place the barrel plug
2) Select a suitable installation location for the wall bracket
3) Drill two holes about 62 mm apart. Use the wall bracket
4) Push the wall plugs into the holes and then screw the wall bracket
5) You can place the nozzles on the accessories holder on the side.
6) Connect the mains adapter
SAS 7.4 LI B1
care of the batteries, we recommend the following: Once the batteries have
been charged, disconnect the mains adapter
not reconnect the mains adapter
vacuum cleaner's suction power has noticeably decreased.
DANGER – ELECTRIC SHOCK!
Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
shown in the diagram. Secure the barrel plug
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
to ensure the correct spacing. The drill holes must be suitable for 5 mm wall
plugs.
into place using the screws.
with the mains socket until the handheld
of the mains adapter
to a mains power socket.
from the mains socket. Do
into the wall bracket
by turning it.
:
.
to mark the holes,
firmly
GB
.
as
│ 31 ■