Charging; Operation - SilverCrest SAS 7.4 LI B1 Mode D'emploi

Charging

NOTE
►
■
■
■
■
NOTE
►

Operation

CAUTION!
►
NOTICES
►
►
■ 32 │
GB
Check to ensure that the on/off switch
position "0") before starting the charging process.
Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
The charge indicator lamp
Important: The charge indicator lamp
vacuum cleaner is charged enough to vacuum again. This does not mean that
all the batteries are completely charged. When the charge indicator lamp
lights up green, the batteries are charged to around 80%.
When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter .
Do not recharge the batteries again until the handheld vacuum cleaner's
suction power becomes appreciably weaker and the charge indicator lamp
flashes green.
The handheld vacuum cleaner can also be charged directly via the mains
adapter . To do this, remove the barrel plug
wall bracket and insert it into the socket on the handheld vacuum cleaner.
The suction opening must always be open and may not be blocked. Block-
ages lead to overheating and damage to the motor.
Make certain that the dust filter
ance.
When vacuuming liquid, do not exceed the MAX marking in dirt container
has been pushed back (to the
slips into the socket on the handheld vacuum cleaner.
lights up red and the charging process begins.
lights up green once the handheld
is always inserted before using the appli-
with a slight twist from the
SAS 7.4 LI B1
so
.