Metabo PowerMaxx 12 Mode D'emploi page 10

17027022_0811 PowerMaxx 12.book Seite 10 Montag, 1. August 2011 8:45 08
ENGLISH
ENG
Do not use faulty or deformed battery packs!
Do not expose battery packs to naked
flame!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Remove the battery pack from the machine before
any adjustment or maintenance is carried out.
Before fitting the battery pack, make sure that the
machine is switched off.
Keep hands away from the rotating tool!
Remove chips and similar material only with the
machine at standstill.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory
diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in conjunc-
tion with additives for wood conditioning (chro-
mate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
LED (2): Do not view LEDs directly through optical
instruments, LED class 1M, classified as per DIN
EN 60825-1: 2003, wavelength: 400-780 nm;
t =300 µs, 5 lm.
imp
5 Overview
See page 3 (please unfold).
1 Protective cap/bit clamping bush*
2 LED lights
3 Adjusting sleeve (torque control, maximum
torque)
4 Slide-switch (1st/2nd gear)
5 Rotation selector switch (direction of rotation
setting, transporting safety device)
6 Trigger
7 Battery pack release button
8 Battery pack
* depending on model
10
6 Special Product Features
• Angle screwdriver attachment for drilling and
screwing in areas that are hard to reach
(depending on model)
• Hexagon socket holder in the spindle for a
shorter, more lightweight machine.
• Spanner flat for easy chuck changes, even if the
chuck is overtightened.
• Multifunctional monitoring system to protect
the tool and battery pack
7 Use
7.1 The machine's multifunctional monitor-
ing system
If the machine switches off automatically, the
machine electronics have activated auto-
matic protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger is
released (6).
Causes and remedies:
1. Battery pack almost flat (the electronics
prevent the battery pack from discharging
totally and avoid irreparable damage).
If the battery pack is almost flat, it must be
recharged.
2. Long continuous overloading of the machine
will activate the temperature cut-out.
Leave the machine or battery pack to cool.
Note: The machine will cool more quickly if you
operate it at idling speed.
3. If the current is too high (for example, if the
machine seizes continuously for long periods),
the machine switches off.
Switch off the machine at the trigger (6). Then
continue working as normal. Try to prevent the
machine from seizing.
7.2 Battery pack
Charge the battery pack before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C
and 40°C.
Removing the battery pack
Press the battery pack release (7) button and
remove the battery pack (8).
To fit
Slide in the battery back (8) until it engages .