Adjusting Nylon Line; Connecting Charger To Power Supply; Charging The Battery - Stihl FSA 65 Notice D'emploi

English

Adjusting Nylon Line

Adjusting Nylon Line
Hold the rotating mowing head
N
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
2
1
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
Switch off the trimmer.
N
Move the retaining latch to ƒ and
N
remove the battery.
Turn the trimmer on its back.
N
Press down the cap on the spool as
N
far as stop.
Pull the ends of the lines out of the
N
spool.
If the spool is empty, see "Replacing
Nylon Line".
40
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
2
time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must match – see "Connecting the
charger to the power supply"
Operate the charger only in a closed, dry
space at ambient temperatures of +5 °C
to +40 °C (41° F to 104° F) .
Slide the battery (1) into the
N
charger (2) until you start to feel
resistance – then push it in until it
engages
2
FSA 65, FSA 85