Ribimex Ribitech PRBAT20 Manuel D'instructions Et D'utilisation page 35

V. OPERATION
5.1- Intended use
- The product is intended for domestic use (indoor or under shelter).
- The product is intended for cutting small wood materials, within tool's specified limits.
- Use the power tool only for dry work. Water penetration into a power tool increases the risk of electric
shock.
- Do not use the circular saw for working on products containing asbestos or other toxic or hazardous
materials (e.g. lead based paints).
- This power tool may not be used for purposes outside the described scope.
- Do not use the tool for purposes not appropriate (eg cutting of products containing hazardous materials ...),
or for any use not described in this manual.
- The tool is not intended for artisanal, commercial, professional and / or industrial use.
- Do not use other types of cutting blades other than those recommended by the manufacturer to avoid a
hazard.
- The manufacturer or seller cannot be held responsible for incorrect or non-compliant use of machine.
5.2- Operation
Note: Before first use, charge the battery.
1. Ensure that battery is fully charged.
2. Wear appropriate protective equipment.
3. Check blade is not damaged.
4. Prepare material for work
5. Secure material if necessary.
Do not use your own weight or body to hold material.
6. Firmly hold tool to avoid kickbacks. Always maintain a balanced and secure position.
7. Place blade on workpiece. Do not make sudden movements.
8. Press on the trigger switch to start operation.
Note: never touch or grasp the blade during operation.
9. Once work is finished, stop product by releasing the switch.
Note: do not put down product until blade has completely stopped rotating.
Tips: Apply progressive load, excessive pressure overloads the motor unnecessarily, and can cause
damage.
CAUTION! Material Damage! Excess pressure can cause material damage.
WARNING! Do not become careless in assuming your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting strict
compliance to the safety instructions given with the tool.
Improper us of the tool or failure to comply with the provided safety instructions in this manual can cause
severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Stay alert for your surroundings and especially for any danger that you may not hear while using the tool.
5.3- Use
a) Making a cut
With a pencil, mark the line of cut on the work piece.
Adjust the depth of cut and bevel angle as required.
When making 90° cross or rip cuts, align your line of cut with the outer blade guide notch on the base of the
saw.
When making 45° bevel cuts, align your line of cut with the inner blade guide notch on the base of the saw.
Rest the front edge of the base on the workpiece. Make sure the power cord is out of the way of saw the
Page 35 / 60