Ribimex Ribitech PRBAT20 Manuel D'instructions Et D'utilisation page 31

11- Warning!
- Never work on materials containing asbestos (as asbestos is considered carcinogenic).
- Do not assume your knowledge of the tool. Remember that a split second of negligence is sufficient to cause
serious damage and/or injury.
12- In the event of emergency
Stop immediately the tool and unplug from mains.
Assist the injured person with first aid and call for medical assistance as quickly as possible.
13- Do NOT use the tool:
- For other uses that the one specified in this manual.
- When tired or under the influence of drugs, alcohol, or medication.
- In explosive atmosphere (e.g. in presence of flammable liquids, gas, dust ...)
- If the product is damaged or if not fully or securely assembled.
- If the switch is damaged and does not allow to stop the tool.
- If the tool is not working properly, has been dropped, damaged, or dropped into water, do not attempt to
repair it; bring it to your retailer for proper service, replacement or repair, or a person with similar
qualification to avoid any danger.
(D) Safety information about the charger and the battery-pack
Before using the charger and the battery, read all the instructions and cautionary markings on charger,
battery pack and tool.
1) Charger
a) Do not attempt to open or disassemble the charger. If the charger has been dropped or is
damaged in any way, stop using it and do not attempt to repair it. Return the charger for repair to
an authorized service center or a qualified person, to avoid any danger to the user; or discard it
according to local laws.
b) Protect the charger against any heat source (e.g. direct sunlight exposure, fire, heater...). To
prevent any damage to the charger.
c) Do not expose the charger to water, moisture and cold. Electric shock hazard.
d) If the power cord or the plug becomes damaged, stop suing the charger until it has been
repaired by a qualified person. If the supply cord is damaged, it must be replaced by the
manufacturer or its authorized service center, in order to avoid a hazard. Electric shock hazard.
e) Only use the charger provided with the tool, or a same type or same model charger to charge
the battery. The use of other types of charger increases the risk of electric shock, personal injury and
damage.
f) Never attempt to recharge non-rechargeable batteries. Batteries may explode
g) Only use the charge at ambient temperatures between +10C and +40C. Store charger in a dry
location protected from cold where temperature would not exceed +40C. To prevent any damage to
the charger.
h) The charger is intended for indoor use only. Place charger on solid, flat non -flammable
surface and away from any flammable materials when re-charging the battery pack.
Do not recharge the battery pack in a wet or humid environment. The charger and battery pack
may heat during charging process.
Page 31 / 60