Troubleshooting - VALBERG 970262 - WM 612 E W205T Consignes D'utilisation

B
Useful information
6. If the filter cap is made up of two parts, close it by pressing
the tab. If, however, it is made up of just one part, first install
the labels in their places in the lower part, then press on the
upper part to close.
34 EN
B
Useful information

Troubleshooting

Problem
You did not press the Start /
Pause / Cancel button.
The programme does
not start after the door is
If you overload, it will be
closed.
difficult to close the loading
door.
The machine has gone
into safety mode due to
Cannot start or select the
problems with the power
programme.
supply (circuit voltage,
water pressure, etc.)
There may be water in
your machine as a result of
There is water in the
quality control operations
machine.
carried out during
production.
The tap is turned off.
The water inlet hose is bent. • Straighten the hose.
The water inlet filter is
clogged.
The machine goes into
The door may be open.
standby mode after the
programme has been
The water connection may
started or does not suck up
have been done incorrectly
the water.
or the water supply may
be cut off (when the water
supply is cut off, the
cleaning or rinsing indicator
lights will flash).
The drain hose may be
The machine does not drain
clogged or bent.
the water.
The pump filter is clogged.
35
Cause Solution
• Press the Start / Pause /
Cancel button.
• Reduce the amount of
laundry and make sure that
the loading door is closed
correctly.
• To cancel the programme,
use the programme
selector to choose another
programme. The previous
programme will be
cancelled. (see «Cancelling
a programme")
•This is not a problem
and does not affect your
machine in any way.
• Turn on the taps.
• Clear the lint filter.
• Close the door.
• Check the water
connection. If the water
supply is cut off, press the
Start/Pause button after
the water supply has been
restored to restart from
standby mode.
• Clean or straighten the
hose.
• Clean the pump filter.
EN