Connecting The Luminaire To The 24 V Supply Voltage (Selv); Functions Of The Luminaire; Operating Functions - Waldmann TANEO SARL 12 R Mode D'emploi

Functions of the luminaire

4.3 Connecting the luminaire
to the 24 V supply voltage
(SELV)
NOTICE
Material damage caused by wrong
mains voltage.
Damage or destruction of the luminaire.
X The connection must be made by a
skilled electrician only.
X Compare the mains voltage with
the nominal voltage and the fre-
quency specified on the rating
plate and make sure that they are
identical.
X Operate the luminaire with safety
extra low voltage (SELV) only.
2
No. Designation
1
DC +
2
DC -
3 Not connected
Tab. 4: Pin assignment.
NOTE: Please observe the pin assignment
and the socket assignment.
X Plug the plug into the socket provided
for this purpose.
5. Functions of the luminaire
Depending on the luminaire model, the
luminaire has different functions. If you
want to find out which functions the lumi-
naire has, see chapter 2 "Model overview" ,
page 19.
5.1

Operating functions

Switchable
This function can be used to switch the
luminaire on and off.
Dimmable
This function is used to change the bright-
ness of the luminaire.
Suitable for EPA
Luminaires with this function can be
grounded and are suitable for use in elec-
trostatically protected areas (EPA).
1
3
ENG
23