Defrosting (Automatic, Manual); Alarm Display And Acknowledgement; Dixell Electronic Temperature Controller - AHT Kinley Mode D'emploi

Instruction
DE
note
• The following applies for networked cabinets in the
EN
bus system: bus address "001" is absolutely essential.
Bus addresses should not be assigned twice.
IT
Assigning the bus address:
1.) Press and hold key [1] for at least 5 seconds.
FR
"r01" appears on the display.
2.) Press key [1] until
ES
"o03" appears on the display.
3.) Press key [2].
PT
The set address is shown on the display (de-
fault bus address is 001).
NL
4.) Assigning a higher bus address:
Press key [1].
DA
Assigning a lower bus address:
Press key [3].
FI
5.) To add a new entry:
Press key [2].
SE
6.) Assigning bus addresses for subsequent cabinets:
Repeat points 1.) to 5.) and set the next free
bus address.
NO

9.1.4 Defrosting (automatic, manual)

SL
Defrosting starts automatically.
"-d-" appears on the display.
HR
Defrosting can also be started manually if required.
CS
Procedure for manual defrosting
1.) Starting manual defrosting:
SK
Press key [3] for at least 5 seconds.
"-d-" appears on the display.
PL LED symbol "
2.) Ending manual defrosting:
ET
The cabinet returns to normal operation auto-
matically.
LT
3.) The temperature is displayed again 30 minutes
after the end of manual defrosting.
LV

9.1.5 Alarm display and acknowledgement

HU
Alarm display:
The alarmis signalled by the left LED symbol on the
RU
display flashing.
Displaying the relevant error code*:
RO
Press key [1].
There is also the option of outputting an acoustic sig-
EL
nal through an additional installed buzzer.
Fault acknowledgement
TR
1.) Press key [1] briefly.
The error code and associated acoustic alarm
BG
are acknowledged (if connected).
36
" appears.
2.) Calling up the error code
Press key [1] briefly.
Fault code list
Fault code* Meaning
E 1 Controller error
E 6 Replace battery
+ check clock
E 25 Sensor S3 error
E 26 Sensor S4 error
E 27 Sensor S5 error
A 1 High temperature alarm
A 2 Low temperature alarm
A 60 HACCP alarm
9.2 DiXeLL electronic
temperature controller
Two types:
controller for standard compressor
controller for VS compressor
There are four control keys. They are used as follows:
Fig. 3 DIXELL controller, controls and displays (symbols)
no. Control
1 [Up] key
2 [Down] key
3 [Defrost] key
4 [SeT] key
5 Unassigned key
6 Unassigned key
Function
- Increase the set-
point/bus address
- Lower the setpoint/
bus address
Start manual defrost
- Access program-
ming level
- Setpoint adjustment
- Apply
bus address