Electrical Connection; Power Supply - AHT Kinley Mode D'emploi

Fig. 1/1: Wall installation: KINLEY with refrigerator/freezer at bottom
(front and side view) – symbols
Fig. 1/2: Wall installation: KINLEY XL with refrigerator/freezer at bottom (front
and side view) – symbols
Fig. 1/3: Island installation: KINLEY with dual stand and refrigerator/freezer at
bottom (front and side view) – symbols
Fig. 1/4: Island installation: KINLEY XL with dual stand and refrigerator/freezer
at bottom (front and side view) – symbols
- Do not place the cabinets in front of radiators, heat-
ing systems and in the vicinity of air outlets.
- Do not install heat sources or spotlights (e.g. light
bulbs) in the cabinet. Any heat radiation in the cabi-
net will lead to increased operating costs and may
impair the performance of the cabinet.
- Advertising posters must only be stuck on as thin
films. Ventilation openings (air grilles), temperature
displays, safety notes and the rating plate must not
be covered.
- Do not attach any thick insulating materials to the
exterior walls.
- Any other structures in or above the cabinet (e.g.
shelves with longitudinal struts), which prevent heat
dissipation between appliances must be avoided. If
structures are necessary between the cabinets, their
design must be approved in writing by AHT.
- It is not permissible to drill into the cabinet in order
to attach the condensation trays, for example.
- Before starting the cabinet, fill the rear condensation
tray with about 1 litre of water.

6. Electrical connection

notes
• It is imperative to adhere to and comply with the re-
gionally applicable requirements of the local power
supply company and the generally applicable nation-
al standards and safety requirements.
• The network voltage and network frequency must
correspond with the nominal values displayed on the
rating plate of the cabinet.

6.1 Power supply

WARNING
Risk of electric shock
People may be careless and come into con-
tact with the electric circuit.
➤ Work on the electrical system must only
be carried out by AHT authorised special-
ist personnel.
➤ Damaged network connection cables
must only be replaced by AHT authorised
specialist personnel.
➤ Contact our AHT service partner (see →
Chapter 16) about this.
Instruction
DE
EN
IT
FR
ES
PT
NL
DA
FI
SE
NO
SL
HR
CS
SK
PL
ET
LT
LV
HU
RU
RO
EL
TR
BG
33