Q.seat Sling Upholstery And Cushion; Adjustment; Cushion Installation; Storage Tips - Zippie X'CAPE Mode D'emploi

Z I PP IE X' CA PE
Q. SEAT SLING UPHOLSTERY AND CUSHION
The seat sling can be adjusted through the use of hook and loop material beneath the seat. Seat sling also
includes a folding strap on the seat to assist in folding the chair.
NOTE - The seat sling folding strap is not intended as a carrying strap.

1. Adjustment

a. Remove seat rail end caps at the front or rear of the chair (D).
b. Slide the seat sling, plastic retaining rods, and spacers (if present) from the channels in the seat rails.
c. For fixed Front Frame, You must remove the 4 screws (E) that hold the rear caps and remove the
caps. By removing the retaining rods first you can then remove the Sling upholstery.
d. Readjust hook and loop material to obtain the desired tension in the seat sling.
e. Reinsert the seat sling and plastic retaining rods into the channels in the seat rails.
NOTE - The seat sling needs to be installed so that the "window"(F) is aligned with the Locking tab.
f. Replace the end caps.
2. Seat sling Upholstery
a. Check monthly for excessive stretching of the upholstery, or loose attaching hardware. If you deter-
mine the upholstery can no longer be adjusted tight, contact your service representative for a replace-
ment.

3. Cushion Installation

a. Place cushion on the seat sling with hook material side down. The beveled edge of the cushion should
be facing toward the front of your chair.
b. Press firmly into place.
R. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts may rust
or corrode.
2. Before using your chair, make sure it is in proper working order. Inspect and service all items on the
"Maintenance Chart".
3. If stored for more than three months, have your chair inspected by an authorized supplier before use.
S. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly pre-
pared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting
your authorized supplier, contact Sunrise customer service. See the introduction page for details on
how to contact your authorized supplier or Sunrise customer service.
30
19
VIII. USE AND MAINTENANCE
30
MK-100090 RevA