Sideguard With T-Post Armrest; Backrest Tension Adjustable - Zippie X'CAPE Mode D'emploi

Z I PP IE X' CA PE
If the chair is equipped with the Dynamic Backrest option, the lockout feature must be in the locked position
on both push handles prior to any type of transport of the chair.
2. Dynamic Backrest Lock Engagement
a. Pull key ring (A) and swing lock downward to unlock backrest.
b. Swing lock upward to lock the backrest.
R. SIDEGUARD WITH T-POST ARMREST
Installation of sideguard
a. Position the Sideguard (B) and Sideguard clamp (C) onto the T-post at a height that will locate the bot-
tom edge of the sideguard next to the frame.
b. Insert two bolts (D) with washer and tighten using 3/16 inch hex key
c. Your sideguard and T-post armrest can now be inserted into the receiver.
NOTE- After installing receiver hardware and inserting the side guard, check for interference. Don't operate
the wheelchair if the sideguard interferes with any of the other components.
S. BACKREST TENSION ADJUSTABLE
1. To install the Backrest Tension Adjustable
a. Slide Velcro straps (E) over the backrest frame (F)section. Make sure to include at least one
strap below the towel bar (if using a rigid chair).
b. Tighten the straps appropriately to desired tension level. DO NOT overtighten straps as
this will cause undue strain upon the chair backrest frame (F).
c. If using inegral push handles (G), slide straps from bottom of backrest upward.
d. Install backrest cover at desired level and fold over rear of Velcro strapping system (H). The
Quickie patch should be upright on the rear of the chair.
e. Finish installation by placing vanity flap (center panel) down onto Velcro on the seat sling to
secure attachment ( I ).
2. Adjusting the Backrest Tension Adjustable
Suggest using anti tips while making any adjustments. Ensure anti tips are safely secured and in a
position to prevent the wheelchair from tipping backwards.
a. User can transfer into wheelchair. Place wheel locks in the locked position
b. From the rear of the wheelchair the attendant can lift the Vanity Flap (Center panel) to
access the strap system. Adjust straps for optimal balance and truck alignment. Ensure the
Velcro straps has a minimum of 2"s of engagement, hook securing to loop. Press the Velcro
together to ensure it's securely engaged.
c. Once adjustments have been finalized replaced Vanity Flap to its original position.
Any changes made to the straps will affect the center of gravity. Suggest the user has the atten-
dant stationed behind the wheelchair to prevent the wheelchair from tipping backwards while they
become accustomed to the adjustment.
MK-100090 RevA
WARNING
56
57 58 59
WARNING
26
IX. DEALER SERVICE AND ADJUSTMENT
Unlocked
55
Locked
A
56
57
58
59