Sideguard; Push Handle - Zippie YOUNGSTER 3 Notice D'utilisation

Adjustable Backrest Upholstery (Fig. 4.18)
The sling can be adapted to any degree of tension by adjusting
the Velcro fasten ers. The padding in the backrest can be
removed through an interior opening, allowing you to cushion
the backrest according to your individual needs.
NOTE!
Too high tension on the adjustable backrest upholstery will have
a negativ impact on the folding performance of your wheelchair.

Sideguard

Sideguard, Aluminum, Bolt-On with Cold-Weather
Protection (Fig. 4.19)
Clothing guards (optional) prevent water from splashing
up and soiling clothing.
Their position relative to the rear wheels can be set by adjusting
the sideguards.
To do this, remove the screws (1 and 2). The armrests
(optional) can be adjusted to the desired height after the
screws have been removed. When finished, make sure
that all screws have been properly tightened (see the
page on torque).
CAUTION:
Neither the sideguards nor the armrests are to be used for lifting
or carrying the wheelchair.

Push handle

Height-Adjustable Push Handles (Fig. 4.20)
These handles are secured with pins to prevent them from
sliding out unintentionally. Opening the quick-release lever (1)
makes it possible to adjust the push handles to meet your
individual needs. As you move the lever, you will hear a locking
mechanism; you may now easily position the push handle as
desired. The nut (2) on the tension lever determines how tightly
the push handles are clamp ed into place. If the nut is loose after
adjusting the tension lever, the push handle will also be too
loose. Turn the push handle from side to side before use to
make sure that it is clamped securely enough into place.
CAUTION!
After adjusting handle height, always clamp the tension lever
(1) securely into place. If the lever is not secure, injuries could
result when lifting over obstacles.
CAUTION!
Check the clamping force (screws) of the adjustable push
handles before use
Fig. 4.18
Fig. 4.19
2
1
Fig. 4.20
2
1
17
YOUNGSTER 3