Standard Sling; Crutch Holder; Tray; Transit Wheels - Zippie YOUNGSTER 3 Notice D'utilisation

Standard Sling

Standard Sling (Fig. 4.27)
The sling is equipped with a Velcro fastener on one
side; this permits stepless adjustment of the sling. To
readjust the sling, first fold up the wheelchair slightly.
Then re move the screws (1) and pull the front plugs (2)
forward out of the frame. The sling (3) can then be slid off
of the frame. By un fastening the Velcro, the sling can be
readjusted. Reverse this pro cedure to reinstall the sling.
When finished, make sure that all screws have been
properly tightened (see the page on torque).
CAUTION!
For proper safety, at least 50 % of the Velcro surfaces
must make contact with each other at all times.

Crutch Holder

Crutch Holder (Fig. 4.28)
This device permits crutches to be transported directly on
a wheelchair. It has a Velcro loop (1) to fasten crutches
or other aids.
CAUTION!
Never try to use or even remove the crutches or other
aids while moving.
Übersicht

Tray

Tray (Fig. 4.29)
The tray provides a flat surface for most activities. Before
using a tray, it first has to be adjusted once to the width of
the seat by an autho rized dealer. The user must be sitting
in the wheelchair during the trial run.

Transit Wheels

Transit Wheels (Fig. 4.30 + Fig. 4.31)
Transit wheels should be used wherever your wheelchair
would be too wide if the rear wheels were used (e.g.,
in airplanes, buses, etc.). After the rear wheels have
been removed with the aid of the quick-release axles,
the transit wheels can immediately be used to continue
riding. The transit wheels are mounted so that they are
approx. 3 centi meters above the ground when not in use.
They are thus out of the way when riding, transporting, or
when tipping to pass over obstacles (e.g., curbs, steps,
etc.).
CAUTION!
Your wheelchair does not have any wheel locks when the
transit wheels are being used.
Fig. 4.27
1
3
2
Fig. 4.28
Fig. 4.29
Fig. 4.30
1
Fig. 4.31
19
YOUNGSTER 3