Table des Matières
Publicité
III- SEALING OF MOUNTING SURFACES AND STICKING
- Application of SILICOMET
Product characteristics
!
- Colour : Coulour less.
- Smell : acetic non toxic
- Temperature : resistance - 50°C to + 200°C
- TO BE USED WITH CARE : avoid any contact with eyes and skin and do not smoke.
Disassembly
- Disassemble the units : in the event of sticking, tap the parts to break the film.
- Remove particles of Silicomet as thoroughly as possible.
Assembly
- Clean and carefully degrease surfaces using a solvent or by washing the parts.
- Leave to dry.
- Apply a single beading of Silicomet to one of the bearing surfaces well around the attachment holes
(thickness of beading : 1 mm max.).
- Assemble the parts and tighten to the required torque.
- Leave to dry : can be handled after 1h.- time for complete vulcanization : 24h to 48 h.
- Application of Loctite 549
Product characteristics
- Colour : Red dark
!
- Temperature : resistance - 55°C to + 150°C
- TO BE USED WITH CARE : avoid any contact with eyes and skin.
- IF LOCTITE GETS INTO YOUR EYES, FLUSH THEM WITH WATER FOR 15 MINUTES..
Disassembly
- Disassemble the units : In the event of sticking, tap the parts to break the film.
- Remove particles of Loctite as thoroughly as possible.
Assembly
- Clean and carefully degrease surfaces using a solvent.
- Apply a single beading of Loctite 549 to one of the bearing surfaces well around the attachment
holes (thickness of beading : 1 mm max.).
- Assemble the parts and tighten screws to the required torque.
The parts must be assembled within 10 minutes following the Loctite application.
- Possible handling after 4h - total polymerisation 24h.
4D-04/11
Section 1
Preliminary
-
7 -
Publicité
Table des Matières
