Gazelle Shimano Steps-system Démarrage Rapide page 58

„ Turning the light ON/OFF
If a light is connected to the drive unit, this product can be used to operate the light.
Switching light on/o
Press the light button to switch the lights on or o .
1.
Press the light button.
Changing cycling data
The display can show
• The light power is linked with the main power. The light cannot be turned ON when the main power is OFF.
The cycling data change in the following order when Button A is pressed.
VALUE EXPLANATION
[GEAR] Current gear position (Only available with electronic gear shifting)
[RANGE] Range (The current range based on the selected assistance level)
[DST] Distance cycled
[ODO] Total distance travelled
Resetting distance cycled
. On the main screen: press Button A. (Switches the display with cycling data to [DST])
. Press and hold Button A. (Keep the button pressed until the fi gure for [DST] fl ashes)
. When the fi gure for [DST] fl ashes: press Button A.
. The cycling data has now been reset.
Assistance whilst walking with the bike
. Stop and switch to the walk assist mode. Press and hold ButtonY until icon (G) is
displayed
. Push the bike carefully whilst pressing the same button again. When you release ButtonY,
the assistance stops.
. Leave the walk assist mode. Press button X
GAZ_Snelstart Shimano Steps_21_E02_V01.indd 58
Light button
types of cycling data (D) . Press Button A to switch between these.
10
31-08-2021 09:44