Shimano System Quick Start; Installing A Carrier Type Battery - Gazelle Shimano Steps-system Démarrage Rapide

2. Shimano System quick start

G THE BATTERY
g the Battery
.
. . Drager accu plaatsen
UTION
. Insert the battery into the rail from the
rear of the bicycle
Slide the battery forwards and push
y hold the battery during removal or transport, being careful not to drop it.
firmly into position.
re to do so may cause the components to fall and break or cause injury.
. Return the key to the locked position
and then remove it.
carrier mount type
. . Removing a carrier type battery
ert the key and release the lock.
. Insert the key and release the lock.
( ) Push the on-o button to switch OFF the power, and insert the key into the jack socket
Press the power switch to turn the power OFF, and then insert the key into the socket
on the battery holder.
on the battery mount.
( ) Turn the key until you can feel that contact has been made.
Turn the key until you feel it make contact.
Key
refully remove the battery.
. Carefully remove the battery.
GAZ_Snelstart Shimano Steps_21_E02_V01.indd 48
HANDLING THE BATTERY
Installing the battery
Rear carrier mount type
1.
Insert the battery into the rail from the rear of the bic
Slide the battery to the front and push it in firmly.

Installing a carrier type battery

2.
Remove the key.
Return the key to the locked position, and then remove it.
Down tube mount type
Socket
Power switch
1.
Insert the battery from below.
Align the concave section on the bottom of the battery with the con
battery mount, and then insert the battery.
Rail
31-08-2021 09:44