headboard bracket installation guide
A 9/16" & 1/2" socket and crescent wrench are necessary to complete installation.
HEADBOARD BRACKET COMPONENTS
Headboard Bracket (2)
T-Bracket (2)
STEP 1
a .) Align the hole in the bracket to the brass sleeve into which the leg
threads . Hold the bracket in place and screw the leg into the base until
it is snug . DO NOT OVERTIGHTEN . Too much force may cause the leg to
spin freely .
b .) Align the tab with the hole in the frame (located towards the foot of the
base) and use a short bolt and nut to secure the bracket . Make sure the
bolt is tight .
Use of headboard brackets is optional.
Spacer
Long
Short
Nut (18)
(2)
Bolt (8)
Bolt (10)
STEP 2
Attach the plastic spacer and T-Bracket .
a .) Measure the distance between the mounting holes on the headboard
and install the spacer and attachment plate to accommodate the
headboard .
b .) To install the plastic spacer and attachment plate, you will need (2) long
bolts and (2) nuts . Place the spacer and attachment plate in the desired
location and slip the bolts through the holes with the head of the bolt
facing outward . Position the bolts diagonally on the spacer . Use the
9/16" socket and wrench to tighten the bolts .
STEP 3
You may now connect your headboard to the attachment plates using the
remaining short bolts and nuts to secure it to the brackets . The heads of the
bolts will face outward . Use a 9/16" socket and 1/2" wrench to tighten the
bolts .
15