Headboard Bracket Installation Guide - Ergomotion Serta MotionPerfect III Mode D'emploi

headboard bracket installation guide

A 9/16" & 1/2" socket and crescent wrench are necessary to complete installation.
STEP 1
a .) Align the hole in the bracket to the brass sleeve into which the
leg threads . Hold the bracket in place and screw the leg into the
base until it is snug . DO NOT OVERTIGHTEN . Too much force
may cause the leg to spin freely .
b) Align the tab with the hole in the frame (located towards the foot
of the base) and use a short bolt and nut to secure the bracket .
Make sure the bolt is tight .
STEP 2
Attach the plastic spacer and T-Bracket .
a .) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard .
b .) To install the plastic spacer and attachment plate, you will need
(2) long bolts and (2) nuts . Place the spacer and attachment
plate in the desired location and slip the bolts through the holes
with the head of the bolt facing outward . Position the bolts
diagonally on the spacer . Use the 9/16" socket and wrench to
tighten the bolts .
STEP 3
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets . The heads of the bolts will face outward . Use a 9/16"
socket and 1/2" wrench to tighten the bolts .
13