Weight Limits - Ergomotion Serta MotionPerfect III Mode D'emploi

Masquer les pouces Voir aussi pour Serta MotionPerfect III:
Table des Matières

Publicité

safety precautions and usage statements
PRODUCT RATINGS:
The lift motors are not designed to operate continuously for more than
[2] minutes in an [18] minute time period or approximately 10% duty
cycle . Attempting to circumvent or exceed this rating will shorten the life
expectancy of the product and may void the warranty . The massage
motors are not designed to operate continuously for more than 30 minutes
at a time . Please allow the massaging system to rest for 30 minutes after
automatic massage shut off before restarting.

WEIGHT LIMITS:

This product is not rated to support weights exceeding 850 pounds (or)
650 pounds . This product is not rated to support weights in excess of
850 pounds (or) 650 pounds inclusive of the mattress and bedding . The
base will structurally support this weight, provided it is evenly distributed
across the bed base . The adjustable base is not designed to support or
lift this amount in the head or foot sections alone . Exceeding this weight
restriction could damage the bed and/or cause injury and will void the
warranty .
IMPORTANT DO'S AND DON'TS:
DO:
Plug your adjustable base into a power surge protector .
Evenly distribute weight when sleeping in a split setup . Uneven
distribution of weight can cause the base to raise unevenly .
Call Customer Service for any technical issues . Do not try to force the
base down, this can damage the motors or frame .
Use mild soap and water to clean your adjustable base if staining
occurs .
Keep in mind that adjustable bases are recommended to be used with
adjustable friendly mattresses
Lower to the flat (horizontal) position after use and in between presets.
4
Register your warranty as soon as your adjustable base has been
delivered .
DON'T:
Sit on corners/edges of base, this may warp the frame, struts or foam .
Tilt the base on its side . This can damage the legs and/or leg screws .
Stand or jump on the adjustable base at any time, this can damage
the frame and motors .
Drag the base to move it . Dragging the base could damage the
frame, strip the nut/bolts or break the legs . Purchase castors if you
plan on moving your base routinely .
Enter and exit the adjustable base with the head and/or foot in
the articulated position. Enter or exit your adjustable in the flat
(horizontal) position .
Tinker with or modify base . This will void the warranty .
Press down on the head or foot while actuated can damage frame
and motors .
FCC Compliance:
This device complies with part 15 of the FCC Rules . Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation .
To comply with the FCC RF exposure requirements, no change to
the antenna or the device is permitted . Any change to the antenna
or the device could result in the device exceeding the RF exposure
requirement and void user's right to operate the device .
Radio Frequency: 2 .4 GHz

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Serta motion custom ii

Table des Matières