Weight Limits - Ergomotion Serta Motion Perfect Manuel Du Propriétaire

safety precautions and usage statements
restarting .

WEIGHT LIMITS:

This product is not rated to support weights exceeding 850 pounds . This product
is not rated to support weights in excess of 850 pounds inclusive of the mattress
and bedding . The base will structurally support this weight, provided it is evenly
distributed across the bed base . The adjustable base is not designed to support
or lift this amount in the head or foot sections alone . Exceeding this weight
restriction could damage the bed and/or cause injury and will void the warranty .
IMPORTANT DO'S AND DON'TS
DO:
• Plug your adjustable base into a power surge protector .
• Evenly distribute weight when sleeping in a split setup . Uneven distribution
of weight can cause the base to raise unevenly .
• Call Customer Service for any technical issues . Do not try to force the base
down, this can damage the motors or frame .
• Use mild soap and water to clean your adjustable base if staining occurs .
• Keep in mind that adjustable bases are recommended to be used with
adjustable friendly mattresses
• Lower to the flat (horizontal) position after use and in between presets .
• Register your warranty as soon as your adjustable base has been delivered .
DON'T
• Sit on corners/edges of base, this may warp the frame, struts or foam .
• Tilt the base on its side . This can damage the legs and/or leg screws .
• Stand or jump on the adjustable base at any time, this can damage the
frame and motors .
• Drag the base to move it . Dragging the base could damage the frame, strip
the nut/bolts or break the legs . Purchase castors if you plan on moving your
base routinely .
• Enter and exit the adjustable base with the head and/or foot in the
articulated position . Enter or exit your adjustable in the flat (horizontal)
position .
4
• Tinker with or modify base . This will void the warranty .
• Press down on the head or foot while actuated can damage frame and
motors .
FCC Compliance:
This device complies with part 15 of the FCC Rules . Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation .
To comply with the FCC RF exposure requirements, no
change to the antenna or the device is permitted . Any change
to the antenna or the device could result in the device
exceeding the RF exposure requirement and void user's right
to operate the device .
Radio Frequency: 2 .4 GHz
SAVE THESE INSTRUCTIONS.