Table des Matières
Publicité
safety precautions and usage statements
Ergomotion adjustable bed bases are designed solely for in-home use .
This base was not designed as a hospital bed and is not designed to meet
hospital standards. Do not use this base with TENT TYPE oxygen therapy
equipment or near explosive gases .
WARNING
For optimal safety and operation, plug bed base into a surge protector
(not included). The bed base should only be plugged directly into a
grounded wall outlet or surge protector (strongly recommended). Improper
connection of the equipment can result in the risk of electrical shock,
electrical file or faulty operation of this bed base. If the plug does not fit
your outlet, contact a qualified Electrician to install a suitable outlet.
ADDITIONAL SAFETY FEATURES
Casters (optional leg accessory) are equipped with locking wheels to
prevent unwanted movement . Even when locked and unable to roll, it is
possible for the casters to slide . Free release head and foot motors are
designed to lower the mattress by retracting only with gravity, never pulling
downwards, which minimizes pinch points .
LIFTING/LOWERING MECHANISMS
The lift/lower feature will emit a minimal humming sound during operation .
This is normal . During operation, the lift arm wheels make contact with the
platform support of the base . This contact may result in metal on metal
or metal on plastic contact . This applies slight tension on the moving
components and resonance is reduced to a minimum level . If excessive
noise or vibration is experienced, reverse the movement action (up or
down) of the base with the remote control . This should realign the base's
activating mechanisms to the proper operational position . In normal base
2
ACOUSTICS
operation, the wheels which allow the bed to maintain its distance from
the wall, will make contact with the steel platform supports of the base
creating a contact noise . When entering, exiting or shifting weight on the
base, this contact noise may be audible as the wheels make contact . This
is normal .
MATERIALS
Ergomotion adjustable bases are constructed from various materials
including woods, metals, plastics and fabrics . Tension, pressure or
movement applied to the frame, platform or shroud through general use
may create an audible sound .
MASSAGE OPERATION AND LOCATION ENVIRONMENT
The massage feature will emit a tone during operation . This is normal . As
the massage intensity level is increased, the tone will intensify . The volume
of this tone is directly related to the location environment . For example,
when demonstrated in a show room, the surrounding environmental noise
will cover some of the massage noise . However, when installed in a home
setting with wooden floors, carpeted or not, the massage volume will be
more noticeable . To minimize this resonance, place a piece of carpet, or
rubber caster cups, under each leg or caster of the base . It is possible
to experience vibration or noise from the exterior bed frame, headboard
brackets, headboards or footboards if mounting bolts are not firmly
tightened .
Levels 1-6 of massage intensity represent the revolutions of the motor per
minute . Level 6 provides the maximum number of RPMs . However, this
does not mean that the feeling of vibration is the strongest . Depending on
the mattress material, thickness, and positioning of the user, the feeling of
vibrations will differ. We encourage the user to find the massage intensity
setting that suits them best . It is important to understand the physics
of vibrations . Just as an engine may run rough during idle, as the RPMs
Publicité
Table des Matières
