Table des Matières
Publicité
setting up two bases
If any split setup is being installed, plastic connecting straps are provided (one per base) to
secure the bases together. Use both straps to secure the head and foot portions together.
STEP 1
With the bases in their desired location, slightly loosen both legs
to allow the strap to fit on the leg bolt, between the leg washer
and frame .
STEP 2
Slide side (a) of the connecting strap onto leg bolt . Swing the strap
and connect side (b) to the leg bolt . Secure the strap by shifting to
the left .
a
STEP 3
Re-tighten legs . Do not over tighten . Use the remaining strap and
repeat on other end of the base .
b
17
Publicité
Table des Matières
