Syncing Two Bases - Ergomotion 330 Série Manuel Du Propriétaire

syncing two bases (optional)
If simultaneous operation of two bases is desired, use the SmartSync™ Cord to connect
STEP 1
Unplug base from power source .
STEP 2
Disconnect the power-down box cable from each control box . Make note
where the cable was plugged in .
STEP 3
Connect the male end of each sync cord to control box . Insert it into the same
port that you disconnected the power-down box from in Step 2 .
Control Box
Power-Down Box
the electronics of both bases together.
STEP 4
Connect each power-down box male connection to the sync cord female
connection (Refer to the illustration below) .
STEP 5
Plug base back into the power source .
STEP 6
Check to ensure all cords are securely attached . Both remotes will now
operate both bases simultaneously (If the remotes become unpaired, see
page 15) .
Sync Cord
Splitter
Control Box
Splitter
Power-Down Box
13