Table des Matières
Publicité
installation guide
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply .
STEP 6
Uncoil the Power Cord and connect to the Power
Supply . Place Power Supply on the ground and
extend from the base . Ensure that the Power
Supply and all attached cords are directed toward
the desired surge protector .
STEP 7
Carefully flip the base over on to its legs . Important: Two people are required
to move the bed base . Do not drag across the floor . Do not rest frame on its
side, excessive pressure may damage the legs .
STEP 8
Plug the base into a power source . A surge protector is strongly
recommended.
For customer support, visit www.ergomotion.com or call: US 1-888-550-3746
STEP 9
Ensure batteries are correctly installed in the back of the remote .
Quickly test functions to verify proper setup before placing mattress on base .
Press FLAT to return the base to a flat position .
STEP 10
Locate the mattress retainer bar brackets . Slide the left side of the mattress
retainer bar into the bracket . Pull the retainer bar to the opposite bracket and
secure the right side .
Basic setup is now complete! See page 10-11 for remote control
operating instructions .
9
Publicité
Table des Matières
