Pair Remote - Ergomotion 330 Série Manuel Du Propriétaire

pair remote

The original remote that comes in the box is already paired to the bed base. No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote control .
Remove and replace batteries .
STEP 2
Double click the button on the
Power Down Box (this will not cause
the base to move) . The light will
illuminate .
If the Power Down Box is not available, press Reset button on control box . Pairing LED light on control box will begin to blink . Press and hold button on the
back of the remote, the button will begin to blink . Both lights will become continuous and then simultaneously turn off .
STEP 3
Press and hold button on the back of the remote . The
light will begin to flash then become a continuous solid
light .
STEP 4
Both lights on the Power Down Box and the Remote will
be continuous, then simultaneously turn off . Replace
back cover of the remote .
The remote is now paired with the base .
11