setting up two bases
If a split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases
STEP 1
With the bases in their desired location, slightly loosen both legs to
allow the strap to fit on the leg bolt, between the leg washer and
frame .
STEP 2
Slide side (a) of the connecting strap onto leg bolt . Swing the
strap and connect side (b) to the leg bolt . Secure the strap by
shifting to the left .
STEP 3
Re-tighten legs . Do not over tighten. Use the remaining strap and repeat on other end of the base .
24
Connecting straps are secured to the base frame upon delivery.
together. Use both straps to secure the head and foot portions together.
a
b