Installation Guide - Ergomotion e Serie Manuel Du Propriétaire

installation guide

STEP 1
Place the bed base box in a desired location with the top
of the box facing up .
Remove the binding straps and packing materials, making
sure not to puncture the box with any sharp objects .
STEP 2
Remove the bed base from the box keeping the
bottom of the base facing upwards for easier access to
the beds components
STEP 3
To install the legs, thread the washer over the bolt of the
leg with the recessed side facing the leg and tighten by
hand . Do not over tighten.
To install headboard brackets:
See detailed instructions on pages 20-21.
12
Always use two people when setting up the base
STEP 4
To sync two bases with the SmartSync® :
see detailed installation instructions on page 25.
Locate the battery backup strap and install (2) 9 Volt
batteries (batteries not included .) Store the battery
pack in a convenient location to ensure it is easily
accessible in the event of an emergency power outage .
For complete battery backup strap instructions, see
page 22 .
STEP 5
Uncoil input cord
(connected to control
box's power port) and
plug into Power Supply .