Electric Shock Hazard; Important Safety Information - Hatco Flav-R-Savor FSD Série Manuel D'installation

Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING

ElECTRIC sHoCk HazaRD:

• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Turn power switch off, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• Do NoT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. locate unit indoors where
ambient air temperature is a minimum of 21°C (70°f).
• Do not steam clean or use excessive water on unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by Hatco, an
authorized Hatco service agent, or a person with
similar qualifications.
• Do not overfill water reservoir. overfilling can cause
electrical shock. Water reservoir is full when "lo H2o"
stops flashing on CaBINET TEMPERaTURE display.
stop filling when "lo H2o" stops flashing on display.
• Turn power switch off and allow unit to cool before
draining water reservoir.
• This unit must be serviced by qualified personnel only.
service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. failure to use Genuine Hatco
Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement
Parts are specified to operate safely in the
environments in which
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment.
fIRE HazaRD: locate unit a minimum of 25 mm (1") from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
The fluorescent light fixtures in this unit have plastic safety
shields covering the fluorescent tubes to meet National
sanitation foundation (Nsf) standards. To avoid personal
injury and/or food contamination, always operate the unit
with the plastic safety shields properly installed.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an authorized Hatco service
agent or contact the Hatco service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
Form No. FSDCEM-1010
they are used. some

IMPoRTaNT safETy INfoRMaTIoN

This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
Make sure all operators have been instructed on the safe
and proper use of the unit.
Make sure food product has been heated to the proper
food-safe temperature before placing in unit. failure to
heat food product properly may result in serious health
risks. This unit is for holding pre-heated food product only.
Hatco is not responsible for the actual food product
serving temperature. It is the responsibility of the user to
ensure that the food product is held and served at a safe
temperature.
BURN HazaRD: some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
The National sanitation foundation (Nsf) requires that
units over 914 mm (36") in width or weighing more than
36 kg (80 lbs.) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 102 mm (4") legs are available to allow for proper
cleaning access below unit.
Transport unit in upright position only. Before moving or
tipping unit, secure all glass surfaces with tape and drain
water from water reservoir. failure to do so may result in
damage to unit or personal injury.
Use of distilled water in the water reservoir of humidified
units is recommended to preserve the life of electrical and
mechanical components. If non-distilled water is used, the
reservoir will require periodic cleaning and deliming (refer
to the Maintenance section for cleaning procedure). Unit
failure due to lime or mineral deposits is not covered under
warranty.
Do not use deionized water. Deionized water will shorten
the life of the water reservoir and heating element.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
Use non-abrasive cleaners only. abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
3
WARNING
CAUTION
NOTICE