HBM Z6 Série Manuel D'emploi page 8

Safety instructions
6
S Knowledge of the safety concepts of measurement
and automation technology is a requirement and as
project personnel, they must be familiar with these
concepts.
S As measurement or automation plant operating per­
sonnel, they have been instructed how to handle the
machinery. They are familiar with the operation of the
equipment and technologies described in this docu­
mentation.
S As commissioning engineers or service engineers,
they have successfully completed the training to qual­
ify them to repair the automation systems. They are
also authorized to activate, ground and label circuits
and equipment in accordance with safety engineering
standards.
Additional safety precautions
Additional safety precautions to meet the requirements of
the relevant national and local accident prevention regu­
lations must be taken in plants where malfunctions could
cause major damage, loss of data or even personal
injury.
The scope of supply and performance of the transducer
covers only a small area of measurement technology.
Before starting up the transducer in a system, a project
planning and risk analysis must first be implemented,
taking into account all the safety aspects of measure­
ment and automation technology so that residual risks
are minimized. This particularly concerns personal and
machine protection. The transducers function passively
and cannot implement any (safety-relevant) cutoffs. In
the event of a fault, the relevant precautions must estab­
lish safe operating conditions.
A1027-4.1 HBM: public
Z6...