Fitting Accessories; Compressor; Sack Mangle - WAGNER Plast Coat PC 25 Mode D'emploi

Plast Coat 25 · 35
9

FITTING ACCESSORIES

9.1

COMPRESSOR

V 400 suction volume 360 l/min
• Attach compressor holder (item 1, fig. 16) and secure with
star grip (2).
• Place compressor onto holder. Slide retaining plate (3) over
the compressor base.
• Secure the compressor with star grips (4).

2
3
4
1
9.2

SACK MANGLE

Safety note
Danger of crushing.
Do not pace hands under the roller.
Technical data
Roller length: 465 mm
Roller diameter: 66 mm
Weight: 6.7 kg
Putting sack mangle into operation
• Connect crank handle (1, fig. 17) and secure with linch pin.
• Insert sack mangle and sliding cover (2, accessory).
• Screw out star grips (3) about 2 cm.
• Place sack mangle and crank handle (1) on the sliding cover
to the right from the front. Move guide rollers (4) over stop
pins on the underside of the sliding cover.
• Adjust pressure force of the roller (5). Turn the star grips (3)
to the right until they will go no further.
• Turn crank and move sack mangle to the rear as far as it will
go.

1
GB
FITTING ACCESSORIES
2
3
5
4
39