RedHotDot 010482 Notice D'utilisation page 23

Fig. Interface
DESCRIPTION OF INDUCTORS
The flexible Adhesive inductor pad is used for heating metal sheet for a lot of applications. When
you first use the pad to heat painted metal, please start with the power level on Low. Keep moving
the pad over the area to be heated either in a circular or back and forward motion and check the
temperature under the pad every few seconds until you are familiar with how fast various surfaces
get hot with your inductor. Remember that you can burn the paint if you are not careful. As with any
new tool, patience and practice will let you increase the power level and speed with which the
inductor helps you to do your job.
Removing decals, vinyl graphics or striping : with the HOT INDUCTION HEATER set to Low
power, slowly move the pad over the part that you want to remove in a small circular or back and
forward motion. After a couple of seconds, try to lift an edge of the part. If it begins to lift up easily,
then enough heat has been applied, if not, then apply heat for a couple of more seconds and try again.
Older decals, graphics, and striping tend to take more heating time. If you overheat vinyl, it often
gets "mushy" and "bubbly". If this happens, then let things cool down and then try to lift and peel
HOT INDUCTION
HEATER
1
2
3
4
5
6
Adhesive inductor
23
Digital display
Adjustment keys
Thermal protection
Mode selection key
Power heating indicator
Selected mode
EN