RedHotDot 010482 Notice D'utilisation page 19

HOT INDUCTION
EN
HEATER
Fire or explosion hazard
- Do not overheat parts and adhesives.
- Watch for fire; keep fire extinguisher nearby.
- Do not place the unit on, over, or near inflammable surfaces.
- Do not use the product near inflammable substances.
- Do not operate unit in explosive environment.
- Keep aerosol cans and other pressurized containers away from induction heating equipment.
Induction heating can cause burns
- Hot parts and equipment can cause injuries.
- Do not touch hot parts with bare hands.
- Allow cooling time before handling parts or equipment.
- Keep metal jewellery (wedding ring in particular) and other metallic personal items away from the
inductors during operation.
- Remove all jewellery and other metallic objects from body before operating this equipment.
- Persons with metallic body implants should not use this equipment.
Fumes and gases can be hazardous
- Keep your head out of the fumes, do not breathe the fumes.
- If working inside, ventilate the area and/or use extraction system to remove fumes and gases.
- Induction heating of certain materials, adhesives, and fluxes can produce fumes and gases.
Breathing these fumes and gases can be hazardous to your health. i.e. heated urethane releases
hydrogen cyanide gas, which can be lethal to humans.
- If ventilation is poor, use an approved air-supply respirator.
- Read the Material Safety Data Sheets (MSDS) and the manufacturer's instruction for adhesives,
fluxes, metals, consu- mables, coatings, cleaners, and degreasers.
- Work in a confined space only if it is well ventilated, or while wearing an air-supply respirator.
Always have a trained watchperson nearby. Fumes and gases from heating can displace air and lower
the oxygen level causing injury or death. Be sure the breathing air is safe.
- Do not heat in locations near degreasing, cleaning, or spraying operations. The heat can react with
vapours to form highly toxic and irritating gases.
- Do not overheat coated metals, such as galvanized, lead, or cadmium plated steel, unless the
coating is removed from the heated area, the area is well ventilated, and if necessary, while wearing
an air-supplied respirator. The castings and any metals containing these elements can give off toxic
fumes if overheated. See coating MSDS for temperature information.
Flying metal or adhesive can injure eyes
- Wear approved safety glasses with side shields or wear face shield.
Magnetic fields can affect pacemakers
- People wearing Pacemaker should stay away from the product.
- People wearing Pacemaker should consult their doctor before going near induction heating
operations.
Overuse can cause overheating
- Allow cooling time.
- Reduce output or reduce duty cycle before starting to heat again.
- Make sure all air inlets and outlets are not obstructed.
19