Publicité
Les langues disponibles
Les langues disponibles
- These are A-class devices. They are designed to be used in an industrial or professional
environment. In a different environment, it can be difficult to ensure electromagnetic compatibility,
due to conducted disturbances as well as radia- tion. Do not use in an environment exposed to
metallic dust.
PRODUCT DESCRIPTION
The product is ready for immediate use, once correctly connected to the electrical supply. The HOT
INDUCTION HEATER consists of an inductor and an inverter power source. A powerful magnetic
field is concentrated in the inductor when the trigger is activated. When the inductor is applied close
to a ferrous metal, the induction currents create heating in the metal, without actual contact with the
piece of metal to be heated. The product heats up steel, but is not adapted to heat Aluminium,
Copper or Zinc.
The HOT INDUCTION HEATER product can be used for the following applications :
- Remove all adhesives, logos, plastic bands glued on the car body,
- Release metallic parts (rusty bolts, screws, spark plugs, injectors...).
- Remove sealed glass without damaging the trim (rear window, rear quarter panel, sun roof...),
- Remove anti-gravel protection (BLAXON) and seals.
PRODUCT SET-UP
Connect the product to the electrical supply.
Connect the hose with the pneumatic pedal to the front side of the product.
Connect the chosen inductor to the front panel of the product. Make sure to securely tighten the
connection by toppling down the plastic lock.
To switch ON the product, position the switch on the back of the product to the («I») position. The
heating starts if the inductor is placed close to a ferrous metallic part and by pressing the pneumatic
foot-pedal or the switch on the inductor in case the glass inductor is used.
1.
Remote control connector
2.
Inductor connector
HOT INDUCTION
HEATER
3.
On/Off switch
21
EN
Publicité
