RedHotDot 010482 Notice D'utilisation page 22

HOT INDUCTION
EN
HEATER
INSTRUCTIONS OF USE
No-Load: when no metal piece to heat is detected, or if the inductor is used with a non-ferrous
metal, the indicator « no-load » switches ON.
Manual mode: in this mode, the user manually selects the heating power, from the minimum to the
maximum heating power. To enter in this mode, press the MODE key until the LED in front of «
MANUAL » lights up. The digital display shows the percentage of the maximum heating power
(2400W) that the inductor can transfer to the piece of metal. The heating power will be higher if the
inductor is brought closer to the piece of metal. Beware: at maximum power, heating a metal parts
can be very fast!
Automatic mode: in this mode, the product automatically adjusts the heating power depending on
the inductor used, the piece of metal to heat, and the distance between the inductor and the piece of
metal, in order to maintain a constant heating. The device always transfers the same heating power
independently of the distance between the inductor and the piece of metal to heat. To enter in this
mode, press the MODE key until the LED in front of « AUTO » lights up. This mode is particularly
recommended for glass removal. In this mode, the heating power is limited to the « OK » zone on
the front panel, and the product does not heat at maximum power. The digital display shows the
latest value in % used by the product in order to maintain a constant heating power transferred to the
piece of metal. This value corresponds to the setting which could be used in Manual mode to get the
same heating results, in the exact same conditions. Such that if the user needs a bit more, or a bit
less, heating power as compared to the Automatic mode, he knows which setting to use in Manual
mode and then he can slightly adjust the heating power.
Alarm BEEP when heating: an alarm BEEP can be activated in order to hear the heating activity of
the product. If this BEEP is activated, the frequency of the BEEPs will increase when the inductor is
brought closer to the piece of metal, and when the heating is effective. Press the MODE key for 3
seconds in order to activate this BEEP and/or disable it.
Thermal protection: this LED switches ON when the product enters thermal protection, following
overheating inside the product, in order to protect the components of the product. The product stops
as long as this LED stays ON. Leave the product cooling down until this LED switches OFF, in
order to start heating again.
22