Assembly Instructions; Mounting The System Stirrup - FIOR & GENTZ NEURO CLASSIC Notice D'utilisation

Tools for NEURO VARIO-CLASSIC
T20 hexalobular screwdriver/bit
slotted screwdriver 3.5 x 0.6 x 100mm
pin punch 3.5 x 0.6mm
Tools for NEURO VARIO
T10 hexalobular screwdriver/bit
T15 hexalobular screwdriver/bit
T20 hexalobular screwdriver/bit
pin punch 3.5 x 0.6mm
8.

Assembly Instructions

The system joint is delivered fully assembled. All functions are checked beforehand. You
have to disassemble the system joint for mounting it in the orthosis and for maintenance.
To ensure an optimal functioning, follow the assembly instructions below. Secure all
screws with the torque specified in paragraph 8.4. The assembly is illustrated with the
NEURO VARIO-CLASSIC system ankle joint as an example.
8.1

Mounting the System Stirrup

1 Grease the friction surfaces of the bearing nut with orthosis joint grease.
2 Put the bearing nut into the joint's upper part. The bearing nut must be fully inserted in
the opening (fig. 7).
3 Grease the first sliding washer slightly on both sides with orthosis joint grease.
4 Place the sliding washer onto the joint's upper part (fig. 8).
5 Mount the system stirrup (fig. 9).
System Width
14mm
x
x
x
System Width
10mm 12mm
x -
x
-
- -
x
x
16mm 20mm
x x
- -
x x
14mm 16mm
- -
- -
x x
x x
20mm
-
-
x
x
fig. 7
fig. 8
fig. 9
27