Cleaning The Water Tank; Cleaning The Housing - SilverCrest SEMM 1470 A2 Mode D'emploi

NOTE
2) Replace the sieve holder p in the appliance without the espresso
sieve s d.
3) Fill the water tank z with water (approx. 200 ml).
4) Place a suitably large, empty container onto the drip grille 8.
5) Switch the appliance on using the on/off switch i and wait until all control
lamps light up permanently.
6) Press the "Small" espresso button r . The water comes out of the
espresso outlet q and rinses out the pipes. As soon as the water stops
coming out of the espresso outlet q, the cleaning process is complete.
NOTE
► If you want to descale the water tank z and the pipes, proceed as
described in the section "Descaling mode".
NOTE
► You can store the sieve holder p and the espresso sieves s d in the
holders u next to the water tank z.

Cleaning the water tank

1) Pull the plug from the mains socket and switch the appliance off using the
on/off switch i.
2) Remove the water tank z from the appliance and pour out any remaining
water.
3) Clean the water tank z and the water tank lid t in warm water with a
little mild washing-up liquid. Rinse both parts off with clear water to remove
any remaining detergent and then dry them well.
4) Dry the parts thoroughly and replace them in the appliance.

Cleaning the housing

Clean the housing with a damp cloth. For stubborn soiling use a mild detergent
on the cloth.
Ensure that the appliance is completely dry before the next use.
SEMM 1470 A2
The espresso sieves s d are also suitable for cleaning in the
dishwasher.
GB │ IE │
27 ■