Dometic ORIGO 2000 Notice D'utilisation page 16

Using the stove
8.4 Using the heating element
(Dometic ORIGO 2500 and 4300 only)
NOTICE!
A
Never use alcohol and electrical burners simultaneously to prevent
overheating which can destroy the heating element.
➤ If applicable, remove the cutting board or lift the glass lid (both
accessory).
NOTE
I
For your safety the stove will switch off the mains when you replace
the cutting board or close the glass lid (both accessory).
➤ To switch on the heating element push the button
the button "+".
➤ Choose the desired power setting via the buttons "+" and "–".
The power is regulated in five steps and indicated by the LEDs (see table
below).
LED (fig. 3 1, page 2)
No LED glows
LED 1 glows
LED 1 and LED 2 glow
LED 2 glows
LED 2 and LED 3 glow
LED 3 glows
Pushing the buttons will change the power setting by one step, holding
down the buttons will change the power setting by more than one step.
➤ To switch off the heating element push the button "0" symbol.
➤ Let the stove cool down to room temperature, before you place the cutting
board or close the glass lid (both accessory).
16
Dometic ORIGO
and within 10 s
" "
Power setting
heating element is off
20 %
40 %
60 %
80 %
100 %
EN