Table Des Matières - Aim TTi EX2020R Mode D'emploi

Les langues disponibles

The EX2020R is an exceptionally compact and lightweight single output laboratory dc power

supply providing 0 to 20V at 0 to 20A.

The EX2020R uses mixedmode regulation technology which combines switchmode

preregulation with linear postregulation. Special techniques are used to maintain very high

efficiency whilst achieving noise levels that are close to that of a pure linear regulator.

Excellent line and load regulation are matched by low noise and good transient response. High

resolution controls allow accurate setting of voltage and current levels. Remote sense terminals

are provided so that good regulation can be maintained across remote loads at high currents.

The output operates in constant voltage or constant current mode with automatic cross-over and

mode indication. There is a DC output onoff switch.

The EX series incorporates separate digital voltage and current meters on each output. The

meters use bright 14mm (0.56") LED displays and have an update rate of 4 per second providing

near instantaneous response. Simultaneous metering of voltage and current provides accurate

information "at a glance" and avoids any possibility of misinterpretation. When the output switch

is set to "off", the current limit setting is displayed enabling conditions to be set before the load is

connected.

The EX series has been designed to meet the stringent requirements of the latest relevant IEC

standards for safety and EMC, including harmonics emissions. All outputs are intrinsically short

circuit proof, and are protected against external voltages and reverse currents.

Introduction

Table of Contents

Instructions en Francais

Bedienungsanleitung auf Deutsch

Istruzioni in Italiano

Instrucciones en Español

Introduction

Table of Contents