Helo PURE Mode D'emploi page 49

Setting sauna time
Sauna time is set when the heater is OFF. Use the function selection buttons (F) to se-
lect operating time setting. Use the - and + buttons to then select operating time 1-10.
Operating time depends on the max. operating time set, i.e. which program has been
set.
Version 1
1 h 6 min 12 min 18 min 24 min 30 min 36 min 42 min 48 min 54 min
6 h 1 h
10 h 1 h
24 h 2 h
Setting humidity level (Combi)
Use the function selection buttons (F) to select a humidity setting. Use the - and +
buttons to then select humidity levels 0-10. Select 0 (off) by pressing < when humidity
is set to 1. Each step on the scale indicates the length of time for which the element in
the water tank will operate. The temperature obtained depends on the maximum tem-
perature set. Both humidity and temperature can be changed during operation. While
the sauna is heating up, the amount of steam produced depends on the temperature
level that is set. Humidity is prioritised with temperature settings 1-5 and temperature
is prioritised for settings 6-10. When humidity is prioritised, steam is produced accor-
ding to the setting; when temperature is prioritised, humidity only runs once the set
temperature is reached.
When the water reservoir is low, three beeps will sound and the water drop symbol will
flash. Top up with water until a long beep sounds.
After a sauna session ends, when the reservoir has been in use, a sauna drying process
will start. The sauna will be heated to 80 °C for 20 minutes. The ON symbol will flash
to indicate that drying is in progress. To switch off the drying process, press the Off
button (C).
Max. tempera-
ture
40
90 °C
110 °C 40
2 3 4
2 h 3 h 4 h
2 h 3 h 4 h
4 h 6 h 8 h
Set temperature (approx. value, °C)
1 2 3
46 51
48 56
LED indicators
5 6 7
5 h 6 h
5 h 6 h 7 h
10 h 12 h 14 h
4 5 6
57 62 68
63 71 79
49
8 9
8 h 9 h
16 h 18 h
7 8 9
73 79 84
87 94 102
10
1 h
10 h
24 h
EN
10
90
110