Helo PURE Mode D'emploi page 45

Attach the cable and switch to the bracket (see Figures 3 and 4). Remember to position
the switch in accordance with the illustration (the locking tongue should be at the left
side when seen from below). Install the panel on the wall. Use the supplied control
panel cable to connect the panel to the heater. If the cable is too long, it can be shorte-
ned, then use the extra switch supplied. NB: special pliers are required (crimp pliers for
RJ10).
EN
Fig 3
Fig 4
Fig 5
Installation without bracket
Attach the double-sided adhesive to the control panel. Before attaching the panel to
the wall, connect it to the heater to check that everything works. Remove the protective
backing from the adhesive. Connect the panel wire, pass the contact through the hole
in the wall and press the panel firmly against the wall.
If fitting the panel without the bracket but it is necessary to run the cable outside the
wall, the following solution can be used (see Figure 6). This only applies to installation
inside the sauna cabin. Remember that the hole through which the contact will pass
must be min. 30 mm.
Fig 6
45