Helo PURE Mode D'emploi page 44

Installation Guide
The operating panel must be installed indoors in a frost-free environment.
The control panel should be installed outside the sauna room, but can also be installed
inside or outside the sauna/steam room.utanför basturum/ångrum. installing inside
the sauna cabin, the upper edge must not be more than 80 cm above the floor, and
must be at least 30 cm from the heater.The ambient temperature where the Pure con-
trol panel is installed must never exceed 80 °C.
The unit can be mounted on the wall using the bracket or double-sided adhesive supp-
lied. If using the bracket, mount the control panel on the bracket using adhesive.
A 30 mm hole through the wall is required if mounting the control panel directly on the
wall.
When installing the panel inside the steam room/sauna, installation must be directly
EN
to the wall, using the accompanying adhesive or a Tylö embedding frame (item no.
90001056). The wall must be smooth and perfectly clean after hole drilling (30 mm)
before installation. The bracket must not be used.
Fig 1
Remove the protection from the adhesive and secure the panel to the bracket (see
Figure 2).
Fig 2
Installation with bracket
Use the bracket as a template to mark up screw holes
on the wall. Tighten the screws a little until the bracket is
loosely secured.
Secure the adhesive to the bracket (see Figure 1).
44