Installation Of The Outdoor Unit; Wiring - Technibel KGA-04 Notice D'installation

INSTALLATION OF THE
1

Wiring

Wiring For Above 6000W Model (Above 21000BTU/h Model)
1 Remove the self-tapping screws (2 pcs)
onthe maintenance board and take out the
maintenance board.
Maintenance
board
2 Loosen the self-tapping screws (2 pcs) on
board, pass the power wire and signal wire
power wire and signal wire on the terminal
Maintenance
board
Piping cover Ejecting hole
OUTDOOR UNIT
Outdoor unit terminal
Connecting
cable
Terminal board
Fix the cable wire
with anchor cable
Piping cover
Back wiring
Right wiring
6
The cable wire can be led from the back hole
of the piping hole or ejecting hole.
Please utilize outdoor pipe support when
the cable wire is led from the backside.
Outdoor pipe support
(Outdoor pipe support is not required
when leading the cable wire from other places).
5 Install the maintenance board. After the pipes
and cable wire are installed, please seal the
sponge block as per drawing indication.
Sponge
Piping cover