Groeneveld F205424R02 Mode D'emploi page 6

Self-test signals
The following diagram shows the system configuration-specific indications given
on the monitor, display or indicator lights:
Self test
Transporta-
tion:
After
actuation of
the reverse
gear
Off-road:
After starting
the engine
Error mes-
sage:
System - error
Signalling
When an object is detected, the driver is alerted by means of distance-
dependent visual and audible signals. The alerts become increasingly frequent
as the object gets nearer to the vehicle's rear.
On a Greensight with camera, the visual zone alerts are displayed on the
monitor, and the audible alerts by means of an internal buzzer.
The in-cab display variant without monitor alerts the driver visually by means of
LED indicators and audibly by means of an internal buzzer.
There is also a variant available that supplies solely visual alerts and no audible
alerts. Mainly applied to trailers, this version warns the driver using indicator
lights on both sides of the vehicle with light signals.
The tables below explain the meaning of the alert for all variants.
6
Signals in the cab via a
monitor or display
Light Sound
(visible) (audible)
Uninterrupted
GROENEVELD GROENEVELD
audible alarm
F1
F2
F3
for 1 second
F4
Monitor lights
are activated
for a period of
1 second
Display lights
are activated
for a period of
1 second
Uninterrupted
GROENEVELD GROENEVELD
audible alarm
F1
F2
F3
for 3 seconds
F4
Monitor shows
error message
Red and yel-
low lights on
display flash
alternately
Indicator Driver
lights actions
Both
Wait:
lights illu-
Greensight not
minate
ready for use
for 1 sec-
yet
ond
Alter- Report to your
nately Technical
blinking Service
red and (Greensight
yellow not ready for
lights use)
F205424R02