Mounting/Removing Suction Fl Oor Nozzle; Removing/Inserting The Dust Bin; Operation - Cleanmaxx AC-1107-3 Mode D'emploi

Mounting/removing suction fl oor nozzle
• Insert the open end of the telescoping tube in the enclosed fl oor nozzle up to the
stop. Turn the nozzle back and forth slightly in the process.
• To remove a fl oor nozzle pull it off.

Removing/inserting the dust bin

Operation

ATTENTION!
❐ During use, always keep the fl oor nozzle/the telescoping tube away from body parts
and animals and do not reach into them. You could be caught or injured. If something
does get caught in the vacuum cleaner, turn it off immediately (depress the On/Off
switch ).
❐ Only turn on the vacuum cleaner once you are sure that all parts have been
completely mounted and that the dust bin and the fi lter have been properly inserted.
❐ To prevent the cord from becoming too hot when in use, pull at least two thirds of
its entire length out of the device before you switch on the vacuum cleaner. Do not
forcefully pull out the cord up to the stop point (no further than up to the red mark on
the cord) in order to prevent damage!
❐ Always turn off the device fi rst and pull the mains plug out of the socket before you
change a nozzle!
❐ Do not in any case vacuum up the following:
– Liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as bigger glass shards
1. Make sure that the device is properly assembled (see chapter "Assembly").
2. Pull the mains cord only as far out of the housing as you need, ideally up to the yel-
low mark, but no further than up to the red mark on the cord!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the On/Off switch
5. Move the fl oor nozzle over the surface you want to clean. You can pull the vacuum
cleaner like a sled when vacuum cleaning.
09506_de-gb-fr-nl_V1.indb 22 09506_de-gb-fr-nl_V1.indb 22
• Removal: Push the release button on the dust bin and
take it out of the device by the handle.
• Insertion: Take the dust bin by the handle and fi rst place
the bottom of the bin in the device (the bottom is fac-
ing down and handle is facing up). Then push the han-
dle against the device housing until the dust bin audibly
locks into place. Hold the device by the handle and lift it to
check whether the dust bin is properly seated.
to turn the vacuum cleaner on.
22
17.11.2014 13:38:27 17.11.2014 13:38:27