EHEIM aquastar 63 marine Mode D'emploi page 16

English
5. Assembly
Location
‧ Avoid direct sunlight, and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Be mindful of the floor load provided by the entire weight.
Setting up and aligning the base cabinet (⌦A)
1. Place the base cabinet in the desired position.
2. Align the base cabinet horizontally using a spirit level.
‧ Ensure the stability of the base cabinet. We recommend the EHEIM aquarium base cabinets availa-
ble in specialist shops.
‧ A stand can be used for horizontal alignment. Ensure that the stand rests fully on the surface.
Setting up the aquarium (⌦B)
WARNING! Personal injury or material damage.
The aquarium must not be transported or carried when in its filled state.
CAUTION! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium incl. lower frame a on the base cabinet.
6. Commissioning
Removing/setting the cover (⌦C)
The cover can only be removed/set in a closed state.
▶ Removing: Lift the cover out of the hinges of the cover frame from above.
▶ Setting: Place the cover into the hinges of the cover frame from above.
Installing the micro interior filter b, flow pump c and nano skimmer d (⌦D)
DANGER! Personal injury or material damage.
▶ Heed the operating manual for the micro interior filter, flow pump and nano skimmer, especially the
chapters on safety, commissioning and operation!
Installing the LED lights e (⌦E)
1. Place the LED lights in the front light receptacle of the cover frame.
16